Calibrating AXIS

Estimated reading: 1 minute

Initial Calibration

After pairing and suiting up of the AXIS nodes and hub:

In AXIS Control Center, select ‘Calibration Manager’ tab on the left.
Click on ‘Initial Calibration’.
Click on ‘Next’.
Face the screen and hold a T-Pose (as shown below) during the countdown.
Hold the T-Pose until after the calibration screen.

Recalibration

To recalibrate AXIS after Initial Calibration is performed:

In AXIS Control Center, select ‘Calibration Manager’ tab on the left.
Click on ‘Recalibration’.
Click on ‘Next’.
Face the screen and hold a T-Pose (as shown above) during the countdown.
Hold the T-Pose until after the calibration screen.