AXIS

Menu
Join Our Discord
Order Now
Talk To The Community

Pairing AXIS Nodes

Estimated reading: 2 minutes
Starting Up
  1. Using the computer:
    1. Boot up AXIS Control Center.
    2. Select the ‘Device Manager’ tab on the left.
  2. Insert the AXIS Dongle into a USB port on your computer.
The AXIS Dongle can support up to 17 nodes
Initial Pairing
  1. On the AXIS Control Center, click on the “Pairing Mode” button (chainlinks icon) on the top right.
  2. While the node is off, press and hold the node’s button for 4 seconds until the status indicator flash blue.
  3. The nodes that are in pairing mode will appear on the AXIS Control Center nodes drawer, located on the bottom.
  4. Identify the nodes by either one of the following method:
    • Clicking on the node icon twice will vibrate the node
    • Pressing the node’s button twice will shake the node icon
  5. Drag and drop the nodes from the nodes drawer into the square on the silhouette that corresponds with where the node will be worn at.
  6. When the nodes are successfully paired, the status indicator of the nodes will display a teal light.
  7. After pairing all the nodes that you require, click on the “Pairing Mode” button again to exit Pairing Mode.
Re-assigning Nodes To Different Body Parts
Nodes that are already linked to a body part will appear in the squares on the silhouette. To re-assign the nodes to a different body part:
  1. On the AXIS Control Center, click on the “Pairing Mode” button (chainlinks icon) on the top right.
  2. Identify the node you wish to re-assign by either one of the following method:
    • Clicking on the node icon twice will vibrate the node
    • Pressing the node’s button twice will shake the node icon
  3. Drag and drop the desired node into the new location on the silhouette.
  4. Click on the “Pairing Mode” button again to exit Pairing Mode.
It is recommended for first time users to first pair the nodes before putting them on.